Dual HIGH CURRENT POWER DISTRIBUTION (HCPD) WITH VOLTAGE REGULATOR
£48.00
Used for powering Tronsys X8 UAV’s. High current loads are possible for payloads up to 3kg. Has voltage regulator for powering flight controller servo output rails.
Dual HCPD modules allow two battery connections without any cross over of current. A more safe and reliable connection for X8 UAV’s.
Out of stock
Description
Tronsys X8 Multicopter systems requires the two power modules with a four on one motor connection. Each set of four motors are powered separately from separate batteries. Separate battery connections prevents accidental large current circulation trough the powertrain.
Voltage Regulator include for Flight controller servo rail outputs from HCPD module. Also connection for powering winch in isolation from flight controller through additional XT60 lead.
400A High Current pcb Power Distribution board Management Modules.
Hight Voltage circuit breaker plugs.
Voltage Regulator performance and features:
Module property: Non-isolated buck module
Input voltage: 3.2-40V (try not to exceed 38V as input)
Output voltage: 1.25-35V continuously adjustable
Output current: 0-3A
Working temperature: -40~+85 degrees
Working frequency: 180KHz
Conversion efficiency: up to 92% (efficiency related to input, output voltage, current, voltage difference)
Switching frequency: 65KHz
Output ripple: <30mV
Short circuit protection: Limited current 8A
Over temperature protection: Automatically turn off the output after over temperature
Input reverse connection protection: None, (If necessary, please input a large current diode in the input string)
Installation method: Install by 2pcs 3mm screw
Note: this is a step-down module. The input voltage must be higher than the output voltage.
The output current is greater than 2.5a (or the output power is greater than 10W)
Additional information
| Weight | 44 kg |
|---|---|
| Dimensions | 33 × 34 × 45 cm |
| Tronsys Power Distribution options | For X8 Dual battery system, For X4 single battery system |
