High Current Power Distribution (HCPD) with Voltage Regulator
£26.00
Used for powering Tronsys UAV’s. High current loads are possible for payloads up to 3kg. Has voltage regulator for powering flight controller servo output rails.
Out of stock
Description
A single High current distribution module can be used to power Tronsys X4 UAV’s for payload delivery of up to 2kg.
Two High current distribution module is used for Tronsys X8 dual battery UAV’s for payloads of up to 3Kg.
400A High Current pcb Power Distribution board Management Modules.
Hight Voltage circuit breaker plugs.
Voltage Regulator performance and features:
Module property: Non-isolated buck module
Input voltage: 3.2-40V (try not to exceed 38V as input)
Output voltage: 1.25-35V continuously adjustable
Output current: 0-3A
Working temperature: -40~+85 degrees
Working frequency: 180KHz
Conversion efficiency: up to 92% (efficiency related to input, output voltage, current, voltage difference)
Switching frequency: 65KHz
Output ripple: <30mV
Short circuit protection: Limited current 8A
Over temperature protection: Automatically turn off the output after over temperature
Input reverse connection protection: None, (If necessary, please input a large current diode in the input string)
Installation method: Install by 2pcs 3mm screw
Note: this is a step-down module. The input voltage must be higher than the output voltage.
The output current is greater than 2.5a (or the output power is greater than 10W)
